Cutting Speed Fiber Laser / Carlos

Cutting Speed Fiber Laser / Carlos

Cutting Speed

 

Fast Cutting speed

 

When the cutting parameters are been set and the cutting speed is too fast it may cause the following consequences:

1.     Impossible to penetrate, with sparks spraying

2.     Some areas can be penetrated, but some cannot

3.     The entire section is relatively coarse, but it produces no melting stains

4.     Cutting section appears in slanted bars, with melting stains on the lower part.

 

 

Slow Cutting speed

 

1.     It will cause super fusion, and the cut surface is relatively coarse

2.     Cutting joint gets widened, and the entire sharp corner is melted

3.     Cutting efficiency is influenced

 

Determine whether to speed up or down feeding based on cutting sparks (targeted at cutting with low-pressure oxygen)

 

1.     Spark diffuses from up to down

 

 

 

 

2.     The inclining backward of sparks indicates too high cutting speed

3.     Sparks are not dispersed and in a small number gather together, which indicates slow speed

 

    • Related Articles

    • Succesful cut in both directions - Fiber Laser / David

      Sometimes, the fiber laser can not cut in both directions, what does this problem mean? It means that the Fiber Laser can cut to the right but not to the left. For example:  Image 1. Succesful cut to the right Image 2. Unsuccessful cut to the left ...

    • IPG resonator connections to BCL3766 - Fiber Laser / Engineer David

      For the IPG you will have two wire groups to connect to the machine. The first one is the power wire and the second one is the communication. 1. Connect the power cable in the breaker inside the machine: The three phases to the breaker and the ground ...

    • Oil time interval on Fiber Laser / Engineer David

      1. Close the operation software and open "CypConfig" (Configuration software) Then, digit the password "61259023" 2. Then, go to "Outport" 3. In the "Auto Lubricate" section, change the interval to 2880 4. Then, Click on Save and close the ...

    • Faster Guide to install a Space Saver - Fiber Laser / Engineer David

      1st Day 1. Take off the holders that hold the gantry 2. Install the computer 3. Make the levelation  4. Change the Laserhead driver if it´s necessary.  5. Put the arms inside the resonator cabinet and place it on the machine  6. Put the white arms on ...

    • How to change the movement speed on fiber laser / Eng Carlos

      the user can define the speeds according to their preferences to set it, we use the check box located on the right side. when the fast checkbox is selected,  we can set the fast speed we recommend 35m/min ( 22 in/s) when the fast checkbox is ...