CW5200 CHILLER TEMPERATURE CHANGE / Daniel
In the following video you can see the temperature change procedure.
Follow these steps to set the maximum and minimum temperature values for the chiller.
Step 1
To
access the settings, press the 
y SET buttons for 5
seconds, When the number 0 appears, release the buttons
Step 2
With 
button
change the value to number 8 and confirm with “SET” button
Step 3
To set the upper temperature limit, select option "F8" and confirm with the "SET" button.
Change
the temperature with the 
buttons
and confirm with the “RST” button
Step 4
To set the lower temperature limit, select option "F9" and confirm with the "SET" button.
Change the temperature with the buttons and confirm with the “RST” button
Step 5
Select option F8 to check the maximum temperature limit
Select option F9 to check the minimum temperature limit
Note:
After not pressing a button for 20 seconds the controller will automatically exit the settings without saving changes
Related Articles
How to change the Chiller CW5200 to a constant temperature mode? / Engineer David
Most of the time the chiller comes with the intelligent mode as default from the factory. This can cause problems in the summer times and winter seasons because the intelligent mode works with the ambient temperature.. that means that if the ...Procedimiento para cargar los parámetros por defecto de la temperatura del chiller CW5200 / Daniel
Procedimiento para cargar los parámetros por defecto para el Chiller CW5200 Uno de los problemas que El Chiller emite pitidos puede ser que el agua no esté circulando por el tubo pero que el paso del agua esté obstruido, Verifique que las mangueras ...Procedure to Restore Factory Setting for the Chiller CW5200 / Daniel
One of the problems that the chiller emits beeps can be that the water is not circulating through the tube but that the water passage is obstructed, Please check that the inlet and outlet hoses are not bent, If still beeps another problem is the ...Issue with the chiller´s alarm, Test the alarm cable / Daniel
INTRODUCTION When there is a connection problem between the chiller alarm and the machine, the machine cuts but without power to the tube since the high voltage source is disabled. In the chiller the flow alarm and output ports In order to ...Mantenimiento del CHILLER CW5200 / Daniel
LIMPIEZA INTERNA DEL CHILLER CW5200 En el siguiente enlace se puede mirar el video del mantenimiento del chiller CW5200 https://youtu.be/Hlj4s7kGX08 Para hacer la limpieza del chiller se debe seguir los siguientes pasos: Paso 1 Retire los ...