Galvo 30W Rotary Attachment connection / Daniel

Rotary Attachment connection to Galvo 30W machine

 

In the following video you can see the procedure

https://www.dropbox.com/s/gwx228r8r62pr6u/conexi%C3%B3n%20rotador%20galvo.mp4?dl=0

 

 

To connect the rotary to the Galvo E-Series laser machine, follow these steps:

 

Step 1

Take the cable with DB-15 and 3-pin connections and connect to laser generator and driver respectively

Step 2

Connect the rotary cable to the 4-pin connection of the driver and secure with the nut

 

Step 3

Finally connect the power cable to the controller and turn on the switch. The chuck must be secured when the switch is turned on

• Related Articles

• CO2 Versa Rotary Attachment Configuration: 4-Wheel Rim Drive Rotary and Three Jaw Chuck rotary Models / Daniel

  CO2 Machine Rotary Attachment Configuration: 4-Wheel Rim Drive Rotary and Three Jaw Chuck rotary Models   The Rotary Attachment Configuration: (4-Wheel Rim Drive Rotary and Three Jaw Chuck rotary) receive a signal from the Y axis, generating the ...

• Connect the connection kit for the Rotaty Attachment in the machine / Daniel

  To connect the kit sent by the factory for the machines and to be able to adapt a rotating accessory the following steps must be followed Step 1 Identify the 3-pin male terminal, the two-position switch, and the wire with 3 black, brown, and blue ...

• Loading the rotary parameters from Lightburn software / Daniel

  To Load the file that has the parameters for the rotary attachment follow the next steps Check this video to check the procedure https://www.dropbox.com/s/7xy9j12d91w2az0/rotary%20parameters%20from%20lightburn.mp4?dl=0 Step 1 Go to Edit menu and ...

• 4 pin aviation plug size GX20 to connect the rotary in the star machine / Daniel

  GX20 5/8" or 16mm is the size for the 4 pin aviation plug 4 -pin Male plug diameter 15mm 4-pin female plug 15mm GX20 Dimensions and Pins Position for the GX20 Male & Female plug

• Galvo S machine assembly and software installation / Daniel

  After received the galvo machine. you need to follow the steps to install the machine and the software installation in the computer to assembly You need a simple 2 steps Step 1 Install the lifting to the worktable tightening the 4 screws with an ...