How to fix axis 4soft Limit alarm/ Eng Carlos
This error occurs when the focus is at one of the limits. to eliminate it, we use the arrows located on the right side.
After, press reset the focus by pressing the circular arrow.
Related Articles
How to change the limit distance in the z axis of the Worktable? / Daniel
To change the maximum travel of the worktable From RDWorks software: Open the program and enter the File menu after clicking on Vendor Settings, enter the password RD8888, click on the “Read” button, then click on motor, then click on the z axis ...Issue with the chiller´s alarm, Test the alarm cable / Daniel
INTRODUCTION When there is a connection problem between the chiller alarm and the machine, the machine cuts but without power to the tube since the high voltage source is disabled. In the chiller the flow alarm and output ports In order to ...Limit calibration on the X axis UV printer / Stefhany
LIMIT CALIBRATION ON THE X AXIS Step 1: To recognize the limit in the movement of the carriage on the X axis, enter factory mode by clicking on the "Advance", place the cursor on the "Password" box and press Ctrl + F12 to switch to factory mode, ...Flow alarm indicator lights and Buzzer for chiller / Daniel
source: Teyuchiller.comHow to test the proximity sensors are working? / Daniel
To check that the proximity sensors are working well, the following steps must be followed Step 1: Press the menu button on the operation panel, then scroll with the direction buttons to the "Function +" button and confirm with the Enter button. Step ...