Procedure to Restore Factory Setting for the Chiller CW5200 / Daniel
One of the problems that the chiller emits beeps can be that the water is not circulating through the tube but that the water passage is obstructed,
Please check that the inlet and outlet hoses are not bent, If still beeps another problem is the temperature is not well configured, you can load the default settings
In the next video you can see all the procedure.
To Restore to factory setting follows these steps:
Step 1
Turn off the chiller, then press up and down buttons at the same time, and turn on the chiller
Step 2
When shows a rE message release all buttons (Up and down) and the chiller must load default settings
Step 3
To confirm the chiller load the maximun value of temperature 30° and minimun value of 20° enter the configuration pressing up and "SET" buttons at the same time
Step 4
When the 0 number shows release the buttons and with the up button change to 8 number and confirm with" SET" button
Step 5
To see if the maximun temperature by default is set to 30° select F8, for the minimun value select F9 and confirm with "SET" button
Related Articles
Issue with the chiller´s alarm, Test the alarm cable / Daniel
INTRODUCTION When there is a connection problem between the chiller alarm and the machine, the machine cuts but without power to the tube since the high voltage source is disabled. In the chiller the flow alarm and output ports In order to ...CW5200 CHILLER TEMPERATURE CHANGE / Daniel
In the following video you can see the temperature change procedure. https://youtu.be/yyn6Mgja32s Follow these steps to set the maximum and minimum temperature values for the chiller. Step 1 To access the settings, press the y SET buttons for 5 ...Flow alarm indicator lights and Buzzer for chiller / Daniel
source: Teyuchiller.comCHILLER CW5200 MAINTENANCE / Daniel
THE INTERNAL CLEANING OF THE CHILLER CW5200 In the following link you can watch the maintenance video of the CW5200 chiller https://youtu.be/Hlj4s7kGX08 To clean the chiller, follow the following steps: Step 1 Remove the screws from the side covers ...Mantenimiento del CHILLER CW5200 / Daniel
LIMPIEZA INTERNA DEL CHILLER CW5200 En el siguiente enlace se puede mirar el video del mantenimiento del chiller CW5200 https://youtu.be/Hlj4s7kGX08 Para hacer la limpieza del chiller se debe seguir los siguientes pasos: Paso 1 Retire los ...