Raytools BM114 Connections / Engineer David

Raytools BM114 Connections / Engineer David

Here is the following video that shows how to connect the water hoses to the BM114 Raytools laserhead. 

https://www.dropbox.com/s/qj6n7hzj5caxyhh/20210210_144519.mp4?dl=0

The pressure of the assistant air can be adjusted from the valve that came from that hose next to the laserhead. Set it between (100-110psi)
Make sure that all the hoses are connected good, when you turn on the chiller please make sure that you don't have leakings on the laserhead. If that is the case, turn off the chiller and please double-check that the hoses are good, if not cut the end on the hose and try again or replace it if it is necessary.

Fiber Laser Department

    • Related Articles

    • Raytools BM109 Connections / Engineer David

      Here is the following video that shows how to connect the water hoses to the BM109 Raytools laserhead.  https://www.dropbox.com/s/izo7k0iu7n90i32/20201026_092756.mp4?dl=0 Make sure that all the hoses are connected good, when you turn on the chiller ...

    • IPG resonator connections to BCL3766 - Fiber Laser / Engineer David

      For the IPG you will have two wire groups to connect to the machine. The first one is the power wire and the second one is the communication. 1. Connect the power cable in the breaker inside the machine: The three phases to the breaker and the ground ...

    • Ray Tools Driver Connections to BCL3766 - Fiber Laser / Engineer David

      (BM114 Laserhead) In the next picture is the picture about the driver for the Raytools Laserhead BM114 and in the following pictures the process to connect it to the motherboard and machine These are the following wires that the driver works with: ...

    • Space Saver Electric Connections / Engineer David

      This simple diagram will help you to understand how to make the connections for the electric and power part for the machine: Fiber Laser Department

    • FLY 3015 Electric connections / Engineer David

      This simple diagram will help you to understand how to make the connections for the electric and power part for the machine: If you have to install the dust collector ask for help Fiber Laser Department