Recommendations for recognizing cutting patterns in RDMarkVision/ Stefhany

Recommendations for recognizing cutting patterns in RDMarkVision/ Stefhany



RECOMMENDATIONS FOR RECOGNIZING CUTTING PATTERNS


  1. Clear camera display: Press the “Camera para and calibration” box and configure the camera parameters (“Contrast”, “Gain” and “Explosure”) and the light potentiometer located on the right side of the control panel. operation of the machine, which potentiates the light of the camera, until achieving a clear visualization.




  1. Valid Zone: Check the “Valid zone” box and drag the green box to reduce the area over which the camera will recognize the circle.



  1. Ratio: Press the "Camera for and calibration" box and enter the value 0.1 in the "Ratio" box.



  1. Calibration file: Import the calibration file that you can download by clicking on the following link:


https://www.dropbox.com/s/kvhx0h108hjacza/calibration%205mm.mcor?dl=0








    • Related Articles

    • Cutting using patterns in RDMarkVision / Stefhany

      Recommendations in each cut: Verify the camera calibration: • When changing computers • Every time the software is started • When importing a calibration file Verify that the dimensions of the printed file correspond to the dimensions of the digital ...

    • Alerts in RDMarkVision / Stefhany

      ALERTS IN RDMARKVISION The software reports "Not find target" for the following reasons: • The dimensions of the patterns are not according to the dimensions configured in the software. • The dimension of the cutting area is not according to the ...

    • Camera calibration in RDMarkvision / Stefhany

      CAMERA CALIBRATION IN RDMARKVISION Step 1: Configure the initial parameters of the X and Y axes, to do this, locate the “File” tab and press “Set parameter”. Enter the password RD8888 and press “Confirm” to access the initial parameter configuration ...

    • Model set RDMarkVision parameters / Stefhany

      MODEL SET RDMARKVISION PARAMETERS Angle error: The software allows the reading of misaligned patterns, as seen in the following image; Increase the parameter in the box "Angle error", if the design has the patterns with different angle. For aligned ...

    • Recommendations for CO2 laser cutting

      • Prepare the cut file using any vector software like AutoCad, Adobe Illustrator, CorelDRAW, among others.   • Open the cut file using RDWorks, RDMarkVision or MetalCut.  • We recommend to establish layers for processing modes as follows: Interior ...