Suction system maintenance UV printer / Luis y Stefhany
Suction system maintenance
Over time the suction system may lose power for cleaning and maintenance reasons.
After months of use, it is necessary to clean the perforations through which the suction is made on the worktable, since the ink dries and can obstruct each perforation, affecting the suction.
Use a pointed element that allows to clean hole by hole, this will help increase the suction power on the materials.
On the other hand, make sure that the hoses, the pressure valve and the connection T connected to the pump, are completely tight, without air leaks.
Related Articles
Chiller and UV generator installation / Stefhany
CHILLER AND UV GENERATOR INSTALLATION Step 1: Remove the cables located inside the printer and cut the tie that holds them. Step 2: Connect the silicone hoses to the rear connectors of the Chiller, one in "Outlet" and one in "Inlet". Step 3: The ...SUCTION PUMPS CONNECTION / Stefhany
AIR SUCTION PUMPS CONNECTION Step 1: Connect the support valves at the inlet of each pump, as seen below: Step 2: Locate the pumps inside the printer and connect the gray hoses to the T terminal of the backup pump. Step 3: Connect the other end of ...UV printer IP configuration / Stefhany
UV printer IP configuration Step 1: Right-click on the computer's network icon, then click the "Open network & Internet settings" box. Step 2: Press Ethernet and click on the "Change adapter options" box. Step 3: Right click on Ethernet 2 and press ...Site Preparation Requirement for Installation UV Printer / Stefhany
link to download PDF: https://drive.google.com/file/d/1Am88gZOHVrgFxZFw1yUVXubmqtowRfel/view?usp=sharing Site Preparation Requirement for Installation UV Printer 1. Power: 1x 220V 50Hz/60Hz single phase 35amp. Build Two wall plugs with 4ft space ...Common troubleshooting UV Printer / Stefhany
COMMON TROUBLESHOOTING AND ANALYSIS UV PRINTER Nozzle The check appears with empty spaces -Clean the heads by purging -Increase the value of negative pressure 0.5 -Modify the temperature values Nozzle It only expels air and the ink does not reach the ...