Test Laser Source and Laser Tube independent / Engineer David
1. Find the Laser Supply and remove the signal wires that come from the Motherboard and Chiller.
2. Make a bridge between the Water protection (WP) and Ground connections (GND).
3. Connect the green connector to the Laser Source
4. Finally, press the Red button to test if the Laser Tube fire.
If the Laser tube doesnt fire, replace the tube. If it doesnt work, the problem can be on the Laser Source.
If the Laser Tube fire, that means the Source and Tube are in good condition and the problem can be on the motherboard or in the connections.
Related Articles
2- Easy CO2 Laser Tube instalation / Daniel
To install the laser tube, follow the next video https://youtu.be/ZD3TNf99ZHsLaser tube operation check for the warranty claim / Daniel
In the next video you can see the procedure https://youtu.be/IjSVHo0gBU4 To check the status of the laser tube follows the next steps: Step 1 Place a piece of acrylic in front of the tube. Step 2 Set the laser Max Power on the machine at 50% Step 3 ...IPG resonator connections to BCL3766 - Fiber Laser / Engineer David
For the IPG you will have two wire groups to connect to the machine. The first one is the power wire and the second one is the communication. 1. Connect the power cable in the breaker inside the machine: The three phases to the breaker and the ground ...Remote Control Fiber Laser / Engineer David
Start: Start the process Pause: Pause the process Dry cut: It is to make a physical simulation. The machine is going to make all the cutting process without laser and gas. Stop: In case of emergy to stop the process. Blow: Test the gas pressures. ...Oil time interval on Fiber Laser / Engineer David
1. Close the operation software and open "CypConfig" (Configuration software) Then, digit the password "61259023" 2. Then, go to "Outport" 3. In the "Auto Lubricate" section, change the interval to 2880 4. Then, Click on Save and close the ...