Ramp test in a CO2 machine / Daniel
To do the Ramp test in a CO2 Machine follow the steps
Step 1
Place a piece of wood to make the ramp and cut a line on the sheet as the image
Step 2
check the thin line and put the laserhead in that position of the sheet
Step 3
Measure the distance from the nozzle to the material
Related Articles
1- Easy Machine and Worktable Leveling / Daniel
To leveling the machine and the worktable follow the next videos To place Knife blades and honey comb https://youtu.be/JrrI6uHG49o To level the machine https://youtu.be/1N5zerEiXuE To level the worktable https://youtu.be/xj9Kzh8Qhkk3 - Easy CO2 Auxiliary Equipment connection / Daniel
To connect the auxiliary equipment of a CO2 machine follow the next videos Exhaust fan connection https://youtu.be/5rzzkRV7fWA?list=PLXWt--vtyu_xh-fNWXevHN537tsZUN3LP compressor connection ...Star machine auxiliary equipment connections / Daniel
For the dual chiller inlet use only one inlet A, loop a hose in inlet B and outlet B. filled with distilled water until reaching the green level on the gauge. connect the alarm cable in the back of the chiller as shown in the photo below Check the ...Aufero Laser 2 Diode Laser Machine video playlist / Daniel
Aufero Laser 2 Diode Laser Machine In the next link, you can see the youtube video playlist for the machine https://www.youtube.com/watch?v=cuDZabgtt44&list=PLCvoW8cWgVwdW0LNS43SCjEpBOZrMptoM&index=22Aufero Laser 1 Diode Laser Machine video playlist / Daniel
Aufero Laser 1 Diode Laser Machine In the next link, you can see the youtube video playlist for the machine https://www.youtube.com/watch?v=sTXwHu0cfBE&list=PLCvoW8cWgVweZDs3P4-Sw_oyouuw1nR_S