General components UV Printer / Stefhany

MAIN MOTHERBOARD

PRINT CARRIAGE TOP HARDWARE

NEGATIVE PRESSURE SYSTEM

 

• Related Articles

• Chiller and UV generator installation / Stefhany

  CHILLER AND UV GENERATOR INSTALLATION Step 1: Remove the cables located inside the printer and cut the tie that holds them. Step 2: Connect the silicone hoses to the rear connectors of the Chiller, one in "Outlet" and one in "Inlet". Step 3: The ...

• UV printer IP configuration / Stefhany

  UV printer IP configuration Step 1: Right-click on the computer's network icon, then click the "Open network & Internet settings" box. Step 2: Press Ethernet and click on the "Change adapter options" box. Step 3: Right click on Ethernet 2 and press ...

• Common troubleshooting UV Printer / Stefhany

  COMMON TROUBLESHOOTING AND ANALYSIS UV PRINTER Nozzle The check appears with empty spaces -Clean the heads by purging -Increase the value of negative pressure 0.5 -Modify the temperature values Nozzle It only expels air and the ink does not reach the ...

• Change of UV printer connector for American commercial connector / Stefhany

  Change of UV printer connector for American commercial connector The Leviton 931 250V 30A connector is a good choice to replace the main connector of the UV printer and Chiller. The following image shows the wiring diagram, ground (Green), neutral ...

• Site Preparation Requirement for Installation UV Printer / Stefhany

  link to download PDF: https://drive.google.com/file/d/1Am88gZOHVrgFxZFw1yUVXubmqtowRfel/view?usp=sharing Site Preparation Requirement for Installation UV Printer 1. Power: 1x 220V 50Hz/60Hz single phase 35amp. Build Two wall plugs with 4ft    space ...