Laser tube operation check for the warranty claim / Stefhany - David

• Related Articles

• Laser tube operation check for the warranty claim / Daniel

  In the next video you can see the procedure https://youtu.be/IjSVHo0gBU4 To check the status of the laser tube follows the next steps:  Step 1 Place a piece of acrylic in front of the tube.  Step 2 Set the laser Max Power on the machine at 50% Step 3 ...

• 2- Easy CO2 Laser Tube instalation / Daniel

  To install the laser tube, follow the next video https://youtu.be/ZD3TNf99ZHs

• Laser beam Alignment in Dual Max Machine / Daniel

  Laser beam Alignment in Versa Dual Max Machine First of all, you need to level the machine and both the glass and RF  laser tube,  next step is to calibrate the mirrors,   So in the next videos, we show you how to do it. Check the alignment in the ...

• 0 - The laser beam mark should be in the center of the hole in the laser head / Daniel

  To see how the calibration is, we must observe that the mark of the laser beam is in the center of the hole in the laser head, if the two marks overlap but are above the center, it means that the height of the tube is above of the height of the laser ...

• Oil time interval on Fiber Laser / Engineer David

  1. Close the operation software and open "CypConfig" (Configuration software) Then, digit the password "61259023" 2. Then, go to "Outport" 3. In the "Auto Lubricate" section, change the interval to 2880 4. Then, Click on Save and close the ...