Servo Calibration / Fiber Department / Juan David

• Related Articles

• Succesful cut in both directions - Fiber Laser / David

  Sometimes, the fiber laser can not cut in both directions, what does this problem mean? It means that the Fiber Laser can cut to the right but not to the left. For example:  Image 1. Succesful cut to the right Image 2. Unsuccessful cut to the left ...

• Oil time interval on Fiber Laser / Engineer David

  1. Close the operation software and open "CypConfig" (Configuration software) Then, digit the password "61259023" 2. Then, go to "Outport" 3. In the "Auto Lubricate" section, change the interval to 2880 4. Then, Click on Save and close the ...

• IPG resonator connections to BCL3766 - Fiber Laser / Engineer David

  For the IPG you will have two wire groups to connect to the machine. The first one is the power wire and the second one is the communication. 1. Connect the power cable in the breaker inside the machine: The three phases to the breaker and the ground ...

• Faster Guide to install a Space Saver - Fiber Laser / Engineer David

  1st Day 1. Take off the holders that hold the gantry 2. Install the computer 3. Make the levelation  4. Change the Laserhead driver if it´s necessary.  5. Put the arms inside the resonator cabinet and place it on the machine  6. Put the white arms on ...

• Conexiones del recolector de aire en las maquinas Fly / Engineer David

  Como puede observar en la imagen, el recolector de aire necesita 7 salidas y 7 entradas de aire.  De izquierda a derecha (Salidas 1 a 6 y salida del cilindro) conecte las salidas en la parte de arriba.  De izquierda a derecha (Entradas 1 a 6 y ...