Gas Pressures for the operation of a Fiber Laser / Engineer David

• Related Articles

• Oil time interval on Fiber Laser / Engineer David

  1. Close the operation software and open "CypConfig" (Configuration software) Then, digit the password "61259023" 2. Then, go to "Outport" 3. In the "Auto Lubricate" section, change the interval to 2880 4. Then, Click on Save and close the ...

• Faster Guide to install a Space Saver - Fiber Laser / Engineer David

  1st Day 1. Take off the holders that hold the gantry 2. Install the computer 3. Make the levelation  4. Change the Laserhead driver if it´s necessary.  5. Put the arms inside the resonator cabinet and place it on the machine  6. Put the white arms on ...

• IPG resonator connections to BCL3766 - Fiber Laser / Engineer David

  For the IPG you will have two wire groups to connect to the machine. The first one is the power wire and the second one is the communication. 1. Connect the power cable in the breaker inside the machine: The three phases to the breaker and the ground ...

• Succesful cut in both directions - Fiber Laser / David

  Sometimes, the fiber laser can not cut in both directions, what does this problem mean? It means that the Fiber Laser can cut to the right but not to the left. For example:  Image 1. Succesful cut to the right Image 2. Unsuccessful cut to the left ...

• How to upload a file and send it to cut? / Engineer David

  1. Go to file and click on "Import" or "Open" if you have a file already saved from the software In this case, you have to click on "Import DXF file..." 2. Select the design and Press "Open" 3. Then, click on "Layer"  4. Click on "Open" to set the ...