REPLACEMENT OF THE SECONDARY CONTAINER INK PASS VALVE WHEN TWO VALVES PER CONTAINER ARE REQUIRED / LUIS ANDREY
REPLACEMENT OF THE SECONDARY CONTAINER INK PASS VALVE WHEN TWO VALVES PER CONTAINER ARE REQUIRED.
WARNING: THIS PROCEDURE MUST BE PERFORMED WITH THE MACHINE OFF AND DISCONNECTED.
CAUTION: IF THE PROCEDURE IS BEING PERFORMED ON A CONTAINER WITH INK, THE CONTAINER MUST BE DRAINED BEFORE REMOVING THE INK PASS VALVE.
Drain the ink from the container through the operating valve.
Connect a syringe to the lower nozzle of the valve, turn the valve cock to the open position and suck the ink, taking care not to contaminate the area.
After draining all the ink, we close the valve cock again for safety.
Remove the (02) two Allen type screws that secure the valve to the secondary container.
Remove the valve avoiding mistreating the O-ring
Replace the ink valve with a good one.
CAUTION: DO NOT INSTALL THE NEW VALVE WITHOUT THE O-RING AND VERIFY THAT THE VALVE IS THE SAME TYPE AS REMOVED BECAUSE THERE IS A LEFT SIDE FASTENING AND A RIGHT SIDE FASTENING
Related Articles
INK LEVEL SENSOR REPLACEMENT IN SECONDARY CONTAINER / LUIS ANDREY
INK LEVEL SENSOR REPLACEMENT IN SECONDARY CONTAINER WARNING: THIS PROCEDURE MUST BE PERFORMED WITH THE MACHINE OFF AND DISCONNECTED. Remove the (06) six screws from the top cover of the print carriage. Remove the front cover bracket ...How to replace ink pump? / Stefhany
How to replace ink pump? Step 1：Unplug the ink pump power terminal and remove the 2 screws on the mounting bracket. As shown below: Step 2：Remove the ink pump and unplug the two ink tubes on the ink pump (be careful to cut off the ink path firstly to ...INK SUPPLY PROBLEMS (MAIN BOARD SHOWS "6") / Stefhany
INK SUPPLY PROBLEMS (MAIN BOARD SHOWS “6”) The number 6 on the motherboard indicates that one of the secondary ink tanks is empty, each secondary tank has a flow sensor that sends the necessary signal to activate the ink circulation in the system. ...ENCODER TAPE REPOSITION IN PRINTER / LUIS ANDREY
ENCODER TAPE REPOSITION IN IMAXCAN PRINTER WARNING. THIS PROCEDURE MUST BE PERFORMED WITH THE MACHINE OFF AND DISCONNECTED. Check the condition of the Encoder tape in the machine, identifying that it is correctly located throughout its position. If ...Secondary cartridge electrical connections / Stefhany
Secondary cartridge electrical connections On the head processing card, located on the top of the print carriage, connect the cables corresponding to each color, wait for the motherboard display to show the number 0, this will indicate that the tanks ...